Pointek Cls300 Standard, Cable Version - Siemens POINTEK CLS200 Manual De Arranque Rápido

Pointek CLS300 Standard, Cable Version

When shortening a PFA cable, be sure to take extra care not to damage the
Caution:
PFA coating.
Methods
1. An angle grinder (preferably with a disc suitable for stainless steel)
or
2. Wire cutters (suitable for piano cable
Procedure
1. Loosen the three set screws and pull weight from the cable.
2. Grind/cut the cable to the required length, and then remove rough edges from the
cable.
3. Ensure that cable strands are properly seated in the lay of the cable (i.e. no wire
strands sticking outside the normal cable profile). Make sure ALL strands are
properly seated before continuing the assembly.
4. Push the weight onto the cable while simultaneously rotating it counter-clockwise
around the cable. Make sure that no cable strands are pushed out of their position
in the cable and that the cable is fully inserted.
5. Re-fasten the weight by tightening the three set screws.
Page 78 Pointek CLS200/300 Standard – OPERATING INSTRUCTIONS
6 to 9 mm).
Ø
cable
weight
7ML19985JH04