Specifications: Standard Model; Pointek Cls200/300; Power; Performance - Siemens POINTEK CLS200 Manual De Arranque Rápido

Specifications:
Siemens Milltronics makes every attempt to ensure the accuracy of these
Note:
specifications, but reserves the right to change them at any time.

Pointek CLS200/300

Power

• supply
• power consumption

Performance

• Repeatability

Interface

• configuration
• local display
• output
• polarity-independent
• failsafe

Alarm Outputs

• relay
• solid-state switch
• time delay
• hysteresis
• failsafe operation
• delay timers
Page 6 Pointek CLS200/300 Standard – OPERATING INSTRUCTIONS
Standard model
12 to 250 V AC/DC (0 to 60 Hz)
2W max.
±1% of measurement
locally, using dip switches and potentiometers
3 LED indicators
relay contact and solid-state switch
yes
relay and solid-state switch can be de-energized in
the absence of a sensor signal
1 Form C (SPDT) contact (selectable NC or NO
contact)
max. switching voltage/current (DC): 30 V DC / 5 A
max. switching voltage/current (AC): 250 V AC / 8 A
(resistive load)
rated 30 V DC or peak 30 V AC, 82 mA
ON/OFF alarm, selectable
1 to 60 seconds duration

dependent on
r
Failsafe High or Failsafe Low
2: Alarm ON to OFF and Alarm OFF to ON
: max. 2 mm (0.08") @
7ML19985JH04

= 1.5
r