Start Up; Configuration - Siemens POINTEK CLS200 Manual De Arranque Rápido

Start Up

After Pointek CLS300 is properly mounted and the switch bank is set up, apply power to
the unit. The green LED (L3) glows, indicating the unit is powered and operational.
Setpoint Adjustment
switches
P1
delay
L1
sensor
L2
status
output
(yellow)
status
(red)
Use the potentiometers P1 and P2 to adjust the alarm setpoints. Follow the setup
procedure for the application that most closely describes your operation:
Application
General
Demanding
Interface
detection
General applications (Failsafe Low, no delay)
Preparation
• Ensure that L3 (green) is lit.
• If the yellow sensor status LED L1 is on, turn trip point potentiometer P2 clockwise
until it is off.
• Turn the delay potentiometer P1 fully counter-clockwise (to minimum).
• Set dip switches S1 to S4 to OFF, and S5 to ON (high sensitivity).

Configuration

1. With sensor uncovered and a minimum 100 mm (4") free space all around, turn the
trip point potentiometer P2 counter-clockwise until L1 (yellow) glows.
2. Turn P2 back (clockwise) until L1 stops glowing.
1.
When S3 is set to ON, it inverts the relay function, and the functioning of S1 and S2.
Page 38 Pointek CLS200/300 Standard – OPERATING INSTRUCTIONS
1
.
P2
trip
point
L3
power
(green)
Material
• dry solids
• low viscosity liquids
• hygroscopic / wet solids
• high viscosity and high
conductivity liquids
• liquid A / liquid B
• foam / liquid
O
1 2 3 4 5
F
F
/ROCKER DOWN
Switches shown in OFF position.
Setup conditions
sensor uncovered;
min. 100 mm (4") free space all around
sensor immersed then uncovered; but
retaining max. possible material buildup
immerse sensor in whichever material
has lowest dielectric constant
1
delay: alarm activation
delay: alarm deactivation
1
failsafe/alarm
test delay settings
sensitivity (High or
Low gain)
S5
ON
(high)
OFF
(low)
OFF
(low)
7ML19985JH04