Process; Approvals (Verify Against Product Nameplate) - Siemens POINTEK CLS200 Manual De Arranque Rápido

Process

Please see
Note:
Pointek CLS300 Standard Pressure versus Temperature Curves
and
• relative dielectric constant (r
• CLS200 temperature:
- without thermal isolator –40 to 85 °C (–40 to 185 °F)
- with thermal isolator
• CLS200 pressure (vessel):
- rod version
- cable version
- sliding coupling version
• CLS300 temperature:
- rod/cable version
without thermal isolator
- rod/cable version
with thermal isolator
- high temperature version –40 to 400 °C (–40 to 752 °F)
• CLS300 pressure (vessel): –1 to 35 bar g/–14.6 to 511 psi g (nominal)

Approvals (verify against product nameplate)

CLS200
• General Purpose
• Dust Ignition Proof
• Dust Ignition Proof
with IS Probe
• Explosion Proof Enclosure CSA/FM Class I, Div. 1, Gr. A, B, C, D
with IS Probe
• Flame Proof Enclosure
with IS Probe
• Marine
• Overfill Protection
• Others
EN 61326 (CE EMC) testing was conducted on the Pointek CLS200 while
Note:
mounted in a metallic vessel and wired using shielded cable, where the cable was
terminated in an EMC cable gland at the device entry point.
1.
at process connection
Page 10 Pointek CLS200/300 Standard – OPERATING INSTRUCTIONS
Pointek CLS200 Standard Pressure versus Temperature Curves
1.5 minimum
1
–40 to 125 °C (–40 to 257 °F)
–1 to 25 bar g/–14.6 to 365 psi g (nominal)
–1 to 10 bar g/–14.6 to 150 psi g (nominal)
–1 to 10 bar g/–14.6 to 150 psi g (nominal)
1
–40 to 85°C (–40 to 185°F)
–40 to 200°C (–40 to 392 °F)
CSA, FM, CE, C-TICK
ATEX II 1/2 D T100°C
CSA/FM Class II, Div. 1, Gr. E, F, G
CSA/FM Class III T4
CSA/FM Class II, Div. 1 Gr. E, F, G
CSA/FM Class III T4
ATEX II 1/2 G EEx d[ia] IIC T6 to T4
ATEX II 1/2 D T100°C
Lloyds Register of Shipping, Categories ENV1,
ENV2 and ENV5
WHG (Germany)
Pattern Approval (China)
on page 45.
7ML19985JH04