Disposal - SICK LE20 Instrucciones De Operación

Operating Instructions
LE 20
WARNING
WARNING
Note
WARNING
8 008 685/Q913/2007-05-21
Maintenance
Full functional test after correction of the fault!
A full functional test must be performed once the fault has been
corrected.
Do not carry out your own repairs!
The protective device must only be repaired by the SICK Service or
by persons authorised by SICK.
7.2

Disposal

The safety evaluation unit LE 20 is designed such that it has the
minimum possible environmental impact. It only uses a minimum of
energy and resources.
Unusable or irreparable devices should always be disposed of in
accordance with the applicable country-specific waste disposal
regulations (e.g. European Waste Key 16 02 14).
We would be pleased to assist you in disposing of these devices.
Please contact us.
Separation of materials
Materials must only be separated by competent persons!
Proceed with caution when dismantling the devices. There is the
possibility of injury.
Before you can take the devices for environmentally-friendly recycling,
it will be necessary to separate the LE 20's different materials.
1. Separate the housing from the remaining component parts
(especially from the circuit board).
2. Take the separated component parts for their appropriate
recycling (see table 7-1).
Component
Product
Housing
Circuit boards, cables,
plugs and electrical
connecting pieces
Packaging
Carton, paper
Polyethylene packaging
Tab. 7-1: Disposal according to components - overview
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
Disposal
Recycling of plastics
Electronic-recycling
Paper/cardboard recycling
Recycling of plastics
GB
Chapter 7
3 1 5