Össur PROPRIO FOOT PSX01 Instrucciones De Uso página 10

Driving
• Before driving, turn the device OFF or set to Standby mode in the Össur Logic mobile app (see "Accompanying
Software" section).
Warning: Take caution when using the device in a motor vehicle. Unintended ankle movement may interfere with
brake and/ or accelerator pedal function.
POWER
The device contains a lithium-ion battery of
Warnings:
– Temperatures below - °C ( °F) or over
battery warnings or prevent the device from moving as expected.
– Using a damaged power supply can lead to electric shock.
– In case of unexpected power loss, the device will stop moving and functioning like a mechanical foot,
resulting in incorrect ankle alignment.
Note: Only use accompanying power supply with the device; failure to do so will invalidate the device warranty.
The device comes with the following power supply:
Manufacturer:
Model No.:
Input:
Output:
CHARGING
Warnings:
– Do not use the device when charging the battery.
– Disconnect the device from the power supply before donning.
The device can be charged turned either ON or OFF.
• Plug power supply DC connector into the charge connector at the back of the device and plug charger into the
wall.
• The LED Indicator Ring on front of the device will display the device is charging, and show when it is fully
charged.
• LED Indicator Ring flashing green at last clockwise position shows charging is in progress.
• LED Indicator Ring displays battery charge level through increasing number of solid green lights (see "Battery
Status" section).
• Charging the device to
A fully charged device can be used for
The device cannot be overcharged.
Charging the battery from fully depleted to fully charged state consumes
VAC / Hz.
FRIWO
FW M/
– VAC, - Hz, . - . A
VDC, . A
% takes approximately . hours. A full charge (
to hours, depending on use.
mAh/ . Wh.
°C ( °F) will affect battery performance. This may result in
%) takes approximately hours.
. VAh at VAC / Hz & . VAh at
10