Advanced Set Up - Össur PROPRIO FOOT PSX01 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
NOTE:
– Make sure the user has access to a level ground walkway long enough to complete at least
strides without interruption, at a consistent self-selected speed. If Auto-Adjustment is not successful after
strides, continue until successful.
– Make sure the walkway surface is completely flat. It is recommended to perform Auto-Adjustment on an
indoor surface. The user should walk in a straight line, while avoiding walking in a semi-circle or turning.
– If the walkway is not long enough for
in a straight line. This will increase the number of strides needed.
– the device will not raise the forefoot during the Auto-Adjustment procedure.
. Ask the user to stand still.
. Enable Auto-Adjustment using the Össur Logic mobile app (see "Accompanying Software" section).
. A single white light on the LED Indicator Ring will light up to confirm Auto-Adjustment has been initiated.
. Ask the user to walk on level ground at a self-selected walking speed. The LED Indicator Ring will light up white
in a clockwise direction, showing successful step registration.
. The LED Indicator Ring will light white and will turn off for an instant, before showing the outcome of the Auto-
Adjustment process.
Auto-Adjustment completed: if successful, an ascending -tone audio sequence will be emitted, and the LED
Indicator Ring will flash white.
Auto-Adjustment failed: if unsuccessful, the LED Indicator Ring will flash yellow, indicating the process needs to be
repeated. Please refer to the "Troubleshooting" subsection below.
Troubleshooting
If Auto-Adjustment is not successful:
• Make sure alignment is correct.
• Make sure there are no obvious gait deviations such as significant circumduction or rotation, as these may
prevent successful Auto-Adjustment.
• Make sure the user is walking at a consistent speed.
• Make sure the user is not walking in a semi-circle or making turns.
Note: The device will not operate normally until successful Auto-Adjustment is confirmed.
Note: Auto-Adjustment must be repeated following changes in alignment.

ADVANCED SET UP

Stair and ramp adaptation can be fine-tuned using the Össur Logic mobile app (see "Accompanying Software"
section). Refer to the in-app instructions for information on how to adjust these advanced settings and other user
preferences.
strides, instruct the user to stop, turn around, and continue walking
adequate
15

Publicidad

Tabla de contenido
loading

Tabla de contenido