Control Panel - Myray Hyperion Instrucciones De Uso

3.1. CONTROL PANEL

On CEPH arm:
The control panel, attached to the column with an arm, allows the unit to be fully and efficiently controlled. The
controls are arranged in 2 areas on the control panel in order to make hyperion use more intuitive and user-friendly.
The "Procedure programming" area is on the left side, from which the user selects the type of procedure to be
performed and technical settings. The "Assisted positioning" area is on the right side, and it includes the controls to
move the unit to position the patient.
In addition, a SD card port (Secure Digital Memory Card) is provided at the bottom. If this card is inserted, the images
can be saved without having to connect the unit to a computer.
To save, press the "B" and "Reset" keys simultaneously.
For the hyperion units equipped with remote X-ray arm, the control panel is positioned on the arm so that hyperion
can be vertically translated and reset.
Long-press the button A to place the machine in its "parking" position.
Button Description
"Procedure programming" area
A) this button is used to select the type of procedure to be performed by first choosing the group
to which the procedure belongs (pan, tmj, sin and CEPH for only series X7) and then selecting
the specific procedure by scrolling the list with keys + or -. The indicator on the left side of the
screen, close to the available procedures, shows the currently selected procedure. The selected
item can also be changed by pressing the button again.
B) This button is used to change automatic selections made by hyperion relating to patient size
and technical factors (kV, mA, sec) highlighting the selected factor. Use the corresponding key
(+ or -) to make the required changes. The selected item can also be changed by pressing the
button again. In addition, the initial settings can be restored by selecting "auto" and pressing the
edit button (+ or -).
Edit button used to select the previous program if a procedure has been selected.
On the other hand, if a technical factor is selected, press this button to decrease it.
Edit button used to select the next program if a procedure has been selected.
On the other hand, if a technical factor is selected, press this button to increase it.
16
1 - Button A
2 - Button B
3 - "Procedure programming" area
4 - Hyperion model only
5 - Port for SD Card
6 - "Assisted positioning" area
OPERATOR'S MANUAL EN