Stihl FS 300 Manual De Instrucciones página 60

English
Guard ring for sawing applications
2
1
For use with circular saw blades
► Attach guard ring (1) for sawing applications
► Fit thrust plate (2)
7.5 Cleaning gearbox and cutting
attachment mounting hardware
The gearbox, its surroundings, the interior of the
shield and the individual mounting hardware for
the cutting attachment should be inspected for
dirt regularly and when changing the cutting
attachment and thoroughly cleaned if necessary.
To do this:
► remove all mounting hardware for the cutting
attachment from the gearbox
7.6 Blocking the shaft
► Push the locking pin (1) as far as it will go into
the hole (2) in the gear – press gently
60
2
1
7 Mounting the Cutting Attachment
► Turn shaft until the locking pin engages
7.7 Mounting the cutting attach‐
ment
WARNING
Use the appropriate deflector for the cutting
attachment – see "Mounting the deflector".
7.8 Fitting the mowing head with
screw mounting
Keep the mowing head documentation in a safe
place.
Reconfiguring a mowing head with interchangea‐
ble threaded connection
M 14
PolyCut 41 - 3
► Check whether the mowing head is fitted with
a collar nut (1) with an M 12 internal thread
If a collar nut with M 14 thread is fitted:
► Remove collar nut with M 14 thread and
replace with the version with M 12 – refer to
reconfiguration instructions in the mowing
head documentation
M 12
1
0458-579-8721-B