Mounting Hardware - Stihl FS 300 Manual De Instrucciones

7 Mounting the Cutting Attachment
7.2

Mounting hardware

Dependent on the cutting attachment supplied as
original equipment with a new machine, the
mounting hardware supplied can also vary.
The mounting hardware is attached to the gear‐
box for transport and has to be removed before
fitting a cutting attachment.
7.2.1 Removing mounting hardware
► Block the shaft
► Using the combination wrench (1) undo the
nut (2) clockwise and remove
► According to version, remove rider plate (3)
and thrust washer (4)
7.3 Checking the thrust plate
The thrust plate is needed to mount all cutting
attachments on the gearbox.
2
1
0458-579-8721-B
1
2
3
4
2
1
The thrust plate consists of the hub (1) with a
captive guard washer (2) mounted on it.
WARNING
Never use the thrust plate without the guard
washer. Thrust plates without a guard washer
must be replaced immediately.
7.4 Fitting the guard ring
The appropriate guard ring must be used accord‐
ing to the cutting attachment used.
The following guard rings are mounted on the
gearbox or available as special accessories:
Guard ring for mowing applications
3
2
1
For optimum shield when using brush knives and
shredder blades
► Attach guard ring (1) for mowing applications
► Fit thrust plate (2) and guard washer (3)
English
59