Package Contents; Installing The Grass Catcher - EMAK EF 92S/13H Manual Del Usuario

 PACKAGE CONTENTS

(1) - Lid
(2) - Lifting lever
(3) - Lower tube
(4) - Side struts
(5) - Lower brace
(6) - Handle
(7) - Sack (mesh)
(8) - Frame
(9) - Grass catcher hitches
(10) - Hitch
(11) - Joining material
Four replacement shear pins for the cutting blades are packaged with the grass
catcher.
Store these pins for later use.
 GRASS CATCHER - MAIN PARTS (TERMINOLOGY)
(1) - Lid
(2) - Lifting lever
(3) - Lower tube
(4) - Side struts
(5) - Lower brace
(6) - Handle
(7) - Sack (mesh)
(8) - Frame
(12) - Grass catcher hitch switch

 INSTALLING THE GRASS CATCHER

Screw the grass catcher hinges (9) and hinges (10) on to the rear plate.

- On some machines, the hinges (9) are already pre-mounted on the rear plate.
- Hinge (10) is attached only if a trailer is used.
Insert M5x16 bolts into the top holes in the front frame attachment brackets at the top,

and secure in place with a washer and nut and tighten lightly. Pull tight the pre-mounted
bottom bolts. On to the right side of the front frame tube, into the lower hole, using two
bolts screw on the grass catcher hitch switch.
Screw on the side struts of the grass catcher. The struts are attached to the inner side of

the grass catcher using M5x16 bolts and nuts.
Screw the bottom tube to the frame. For easier assembly, we recommend that the grass

catcher is turned upside down. Attach it to the side braces and to the front frame tube
using M5x3 bolts and nuts.
Slide the grass catcher sack on to the frame. Pull the rubber sides of the sack over the

tubes.
29
3.3.2a
3.3.2b
3.3.2c
3.3.2d
3.3.2e
3.3.2f
3.3.2g