Description And Function Of Controls; Standard Controls - EMAK EF 92S/13H Manual Del Usuario

4. CONTROLLNG THE MACHINE
4.1 CONTROL LAYOUT
(1) Throttle lever
(2) Motor hours counter
(3) The mowing function activation switch when the grass catcher is full
(4) Mowing deck activation switch
(5) Indicator light showing that the brake pedal is stepped on and the parking brake is
engaged
(6) Main power switch
4.1
(7) Forward drive pedal
(8) Reverse drive pedal
(9) Parking brake controller
(10) Brake pedal
(11) Mowing deck elevation adjustment lever

4.2 DESCRIPTION AND FUNCTION OF CONTROLS

4.2.1 STANDARD CONTROLS

(1) ACCELERATOR LEVER
Regulates engine RPM. Has the following three positions:
* Only on machines with engines BS13, BS17, KO15, TE17 and HO16
(2) ENGINE HOUR GAUGE
The operational hour counter implicitly displays the total number of motor hours. Press the Mode button
to switch between the following service functions:
TMR 1 - individual trip counter. Zeroing is carried out by
OIL CHG
- oil change. The function includes two intervals
AIRFILTER SVC - cleaning or changing the oil filter, the interval
Two hours before the end of the set interval the display will show a message lasting 10 seconds.
At the end of the interval the display will show a message NOW.
Zeroing of any of the above mentioned alarms is carried out by holding down the Mode button for
6 seconds.
STARTER*
MAX
MIN
holding down the Mode button for 6 seconds.
for an oil change. The first is after the first
5 hours (oil change after the machine has
been run in) and is displayed only once. The
second is after 25 hours (standard oil change).
is set to 50 hours.
To cold start the engine
Maximum RPM
Minimum RPM (idle)
32