Brake Pedal - EMAK EF 92S/13H Manual Del Usuario

(10) BRAKE PEDAL

(11) MOWING MECHANISM HEIGHT ADJUSTMENT LEVER
This lever sets the height of the mowing mechanism from the ground.
When driving the machine without mowing, the lever must be set to 7.
(12) BYPASS LEVER – FREE MOVEMENT OF REAR WHEELS
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the machine without using the engine. The lever is located on the rear plate of the machine and has
the following two positions:
4.2.2 OPTIONAL CONTROLS
(1) STARTER
For cold starting the engine.
(2) BUZZER
The buzzer gives off an audible signal when the grass catcher is full.
After the audio signal that the catcher is full, power to the mowing mechanism is not shut off!
Stepping on the brake pedal stops the mower.
The pedal is also used when starting the machine, which can be started
only when the brake pedal is pressed.
The lever has 6 work positions, which correspond to a mowing height of 3 to
9 cm.
The higher the lever's position number, the taller the grass will be after cutting.
Position Rear wheel drive
(0)
(1)
Machines with engines BS13, BS17, KO15, TE17 and HO16 are not equipped
with separate starters.
Lever is extended - for pushing the
DISENGAGED
ENGAGED
35
Use
machine
Lever is inserted - for driving the
machine