Connect The Battery; Grass Catcher; Tools Needed - EMAK EF 92S/13H Manual Del Usuario

3.3.1 STEERING WHEEL, SEAT AND BATTERY
a) Fasten the seat:
Place the seat in its place on the machine and secure it using four bolts, pre-mounted

in the seat. Before tightening the bolts, set the desired position of the seat to match
your body size.
b) Connect the cable to the safety switch:
Connect the electrical cable to the switch connector at the bottom of the seat.

c) Install the steering wheel:
Place the wheel on the column (1) and turn it so that the holes in the steering wheel

and column meet.
Insert the included peg into the hole (2) and pound it with a hammer.

d) Connect the battery:
Bolts and rubber battery caps are located in the bag with the documentation and
other joining material.
Turn the lever of the storage space cover located under the steering wheel to open

the cover and take it out.
Loosen the bolts on the battery's pole terminals.

Attach the red cable to the battery's positive (+) pole and secure it with the bolt.

Attach the brown cable to the battery's negative (–) pole and secure it with the bolt.

Place the rubber caps on to both leads.

Put the storage space cover back and secure with the lever.

- Connecting the cables backwards can damage the machine.
- When disconnecting the battery, always disconnect the negative (–) terminal first.
- When installing, using and maintaining the battery, follow the instructions described in the
battery manual. At the same time, observe all of the manual's safety instructions.

3.3.2 GRASS CATCHER

The grass catcher is delivered in a separate box. Some of its parts have been dismantled for transport
and must be assembled first. Later chapters give a rough outline on assembling it. The complete process
is shown on the DVD that is included or can be sent upon request.

 TOOLS NEEDED

Prepare the following tools for assembling the catcher:
A knife for removing packing

material
 UNPACKING
Remove the packing material. First take out the lid, frame and sack and then the wrapped individual
parts. Unpack these parts and clearly organize them in an appropriate place.
A set of hexagonal socket

wrenches and hex wrenches
28
Phillips screwdrivers or an

electrical hand screwdriver
3.3.1a
3.3.1b
3.3.1c
3.3.1d