Battery Inspection - EMAK EF 92S/13H Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 221
Screw on the lower brace from the bottom side of the grass catcher.
Into the openings in the lid insert the handle and slide washers on to its threaded ends.
Insert the piece assembled in this way through the openings in the top bracket on the
frame and secure the handle using nuts. Do not tighten them yet!
Bolt the lid to the frame and tighten the bolts.
Insert the emptying lever into the holes in the brace inside the catcher.
Into the lower end of the lever inside, insert a bolt and push its threaded portion through
the hole. Secure it from above with a nut and tighten it.
Firmly tighten the nuts securing the handle and tighten the nuts securing the top bracket
of the frame. This completes the installation of the grass catcher.
 BALANCING AFTER INSTALLATION
Take hold of the grass catcher and hang it on the hangers on the rear plate of the machine.
Check for the correct alignment of the grass catcher with the mudguard using the arrows
pressed in the grass catcher lid and the machine cover. Correct any imbalance by loosening
the bolts in the front tube and/or the bolts in the side braces, evening it up and retightening
the bolts.
On a properly adjusted grass catcher the space between the rear plate of the machine and
the front frame tube (8) ( (
If it is not possible to align using the above described method, perform the adjustment by sliding the
grass catcher hitch on the rear plate or the bolts and brackets on the top side of the hitch.
3.4 INSPECTING BEFORE STARTUP
3.4.1 CHECKING THE ENGINE OIL
Before checking the oil, the tractor must be in a horizontal position. The oil cap can be accessed by lifting
the seat. Unscrew the dipstick, wipe it clean, reinsert it and screw it back in. Then unscrew it again and
read the oil level.
The oil level must be between the two marks on the dipstick. If it is not, add motor oil until it reaches
the "FULL" mark. The oil type is designated in a separate manual from the engine manufacturer.
The oil must be checked before every ride.

3.4.2 BATTERY INSPECTION

Check the battery according to the manual provided by its manufacturer.
(
(
(
3.3.2b) is no greater than 5 mm.
Oil level on dipstick:
(1) - (ADD) oil is low
(2) - (FULL) oil is full
30
3.3.2h
3.3.2i
3.3.2j
3.3.2k
3.3.2l
3.3.2m

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ef 92s/16hOm 92s/13hOm 92s/16hBlizzard 92/13h

Tabla de contenido