Disposing Of The Machine - EMAK EF 92S/13H Manual Del Usuario

8. END-OF-SEASON MAINTENANCE AND STORAGE
After the end of the season or if you will not be using your machine for more than 30 days, prepare it
for storage as soon as possible. If fuel remains in the fuel tank for more than 30 days, it may form a
sticky sediment, which may hurt the carburettor and cause poor engine performance. Therefore empty
the fuel tank.
- Never store the lawn mower with a full tank of fuel inside a building or in a
poorly ventilated area, where there are fuel fumes, open flame, sparks or ignition
sources, a furnace, central heating, dry rags, etc. Handle fuels and lubricants
carefully. They are highly flammable and careless handling can cause severe
burns or property damage.
- Empty the fuel take only into an approved container and outdoors away from open
flame.
Recommended procedure for preparing your machine for storage:
Thoroughly clean the entire machine, especially the interior of the mowing mechanism (

Do not clean using petrol. Use degreasing agents and warm water.
Repair and repaint chipped paint areas to prevent corrosion.

Remove and replace defective or worn-out parts and tighten all loose nuts and bolts.

Prepare the engine for storage according to the engine user manual.

Lubricate all lubrication points according to the lubrication plan (

Remove the battery, clean it, fill it with distilled water up to the lower portion of the circle in the filling

port, and completely charge it. A drained battery may freeze and burst. If necessary, store the battery
in a cool, dry space. Recharge the battery every 30 days and check its charge regularly.
Cover the mower with a cloth and store it in a clean, dry room.

The best way to keep your machine in top operating condition for next season is to have an
authorized service centre check and adjust it every year.
8.1 MACHINE BELTS
It is not necessary to loosen the belts when the machine is taken out of operation for an extended period
of time. When the machine is started up for use again, we strongly recommend that you allow the
machine belts to run free for at least 5 minutes. This will prevent vibrations and ensure that after
an extended period of inactivity the belts will align into the correct working position.

9. DISPOSING OF THE MACHINE

After the machine's operational life is over, the owner is responsible for its disposal. This may be done
in two ways:
a) Handing the machine over to a company that specializes in this work (scrap yard, automotive junkyard,
secondary waste collection facility, etc.). You will receive a proper receipt when handing the machine
over for disposal.
b) Disposing of the machine yourself. In that case we recommend following the procedure below:
Dispose of the product by recycling the secondary materials according to waste disposal laws.

Disassemble the entire machine.

Clean, pack and store all parts that can be reused.

Divide the remaining parts into those that are ecologically harmless and those that threaten the

environment, such as rubber parts (washers), lubricant residues on bearings or gears. Ecologically
harmful components must be discarded according to waste disposal laws applicable in the user's
country. For example, in the Czech Republic, it is waste disposal law No. 185/2001 Coll.
Separate discarded refuse according to the waste disposal catalogues in keeping with the applicable

decree. Ecologically friendly waste shall be treated as reusable material.
6.4).
54
6.2.2).