Application Software - Mettler Toledo IND570 Manual Del Usuario

1.9.4.3. DeviceNet
The IND570 DeviceNet option enables the terminal to communicate to a DeviceNet network.
DeviceNet is an RS-485-based network using CAN chip technology. This network was created for
bit and byte-level devices. The network can be configured to run up to 500Kbits per second
depending on cabling and distances. Messages are limited to 8 un-fragmented bytes. Any larger
message must be broken up and sent in multiples. The IND570 implementation of DeviceNet does
not support fragmented messages – all messages are 8 bytes or shorter. The network is capable of
64 nodes including the master, commonly called the scanner.
1.9.4.4. EtherNet/IP
This internally installed PCB module enables the IND570 terminal to communicate to EtherNet/IP
Programmable Logic Controllers (PLCs) through direct connection to the EtherNet/IP network at
either 10 or 100 M
messaging (message exchange) are supported by the IND570 software.
1.9.4.5. Modbus TCP
In IND570, the Modbus TCP is made available through the same internal PCB option that supports
the EtherNet/IP protocol. Modbus/TCP is used to establish master-slave/client-server
communication between intelligent devices. It is an open standard network protocol, widely used in
the industrial manufacturing environment. The ModbusTCP protocol takes the Modbus instruction
set and wraps TCP/IP around it.
1.9.4.6. PROFIBUS DP
The PROFIBUS option card enables the IND570 terminal to communicate to a PROFIBUS DP master
according to DIN 19 245 and programmable logic controllers such as Siemens S7 series. The
IND570 PROFIBUS communication solution consists of this internally installed PCB module and
software that resides in the IND570 terminal which implements the data exchange.
1.9.4.7. PROFINET
The PROFINET option card enables the IND570 terminal to communicate to a PROFINET master
and programmable logic controllers such as Siemens S7 series. The IND570 PROFINET
communication solution consists of this internally installed PCB module and software that resides
in the IND570 terminal which implements the data exchange.
1.9.5.

Application Software

The following application software modules can be added to the IND570 to provide additional
functionality for specific workplaces and weighing operations.
1.9.5.1. Fill-570
The Fill-570 is a special application that can be added to the IND570 terminal to provide additional
filling and dosing control. It provides control for the following filling sequences:
•
•
1-18 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
speed. Both implicit messaging (real-time I/O messaging) and explicit
BPS
Dose out to target
Dose out with an automatic
refill of supply material(s)
Fill to target
•
Fill with a dump to
•
empty
Blend (up to 6 materials)
•
Blend (up to 6 materials)
•
with a dump to empty
30205319 | 04| 08/2016