External Usb Adapter - Mettler Toledo IND570 Manual Del Usuario

4. After making the wiring connections as described in the next section, ensure the nut on the
5. Cable shielding should be grounded to the IND570's enclosure by spreading the shield wires
2.4.4.

External USB Adapter

Long-term connection to the USB port on the main board can be made through the available 25mm
cable gland. If quick disconnect of a USB device is required for an application, an optional USB
adapter kit can be installed on the harsh environment terminal to make the USB connection
accessible from outside the harsh enclosure.
TO AVOID DAMAGE TO A CONNECTED USB STORAGE DEVICE WHEN INSTALLING OR REMOVING THE PROTECTIVE
COVER, ALWAYS HOLD THE BODY OF THE COVER AND TURN ONLY THE THREADED RING.
2-14 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
cable gland is tightened properly to seal around the cable. Ensure that this seal is watertight.
as shown at the top of Figure 2-21, then folding them back over the plastic component of the
cable gland before pressing it into the threaded body.
Figure 2-21: Cable Shield Grounding
NOTICE
Figure 2-22: External USB Adapter
30205319 | 04 | 08/2016