Mettler Toledo IND570 Manual Del Usuario página 38

2.3.2.2. Wall Mounting
Two angled brackets are included with a harsh model IND570 for the purpose of mounting the
enclosure to a vertical surface. To wall mount the enclosure, follow these steps:
1. Bolt the two brackets to the bottom of the enclosure using the four M5 screws included with the
2. If the enclosure will be mounted above eye level, proceed to step 4.
3. If the enclosure will be mounted at or below eye level, it will be necessary to reverse the front
2-8 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
terminal. The brackets should be attached as shown in Figure 2-12.
Figure 2-12: Attaching the Wall-Mounting Brackets
cover 180 degrees. Note that reversing of the cover is not possible when the PROFIBUS PLC
interface is installed. If the PROFIBUS option is installed, proceed to step 4. To reverse the front
cover, perform the following steps:
A. Open the enclosure per the instructions provided in the Opening the Enclosures section.
B. Loosen and remove the two nuts securing the two grounding straps (these also operate as
hinges for the front cover) to the rear housing. See Figure 2-13.
30205319 | 04 | 08/2016