Mettler Toledo IND570 Manual Del Usuario página 69

Figure 2-58 shows the array of status indicator LEDs on the PROFINET board. For details on the use
of these LEDs, please refer to the IND570 PLC Interface Manual found on the documentation CD in
the terminal packaging.
2.4.6.10.1. Installation in the Harsh Enclosure
Available Ports
Both RJ45 ports on the PROFINET option are active and can be used when installed into an
IND570. With both ports available, ring and linear PROFINET topographies can be supported with
IND570 terminals.
PROFINET Connector for Harsh Installation
Due to space limitations inside the harsh enclosure, connection inside the IND570 harsh enclosure
requires use of an RJ45 connector (plug and strain gauge) with a total length less than 25mm
(1"). Note: For installations that require the use of an RJ45 connector specified by Siemens,
Siemens offers a special right-angle connector with the appropriate length (<25mm) for use in the
harsh IND570 enclosure (Figure 2-59). However, if this Siemens connector (part number is
6GK19011BB202AA0) is used only one of the ports on the IND570 PROFINET interface is
accessible. In this case, only a single-port topology will be possible.
30205319 | 04 | 08/2016
Link Activity
Figure 2-58: PROFINET Status Indicator LEDs
Note: There is a physical restriction within the IND570 harsh enclosure that will prohibit the use
of some forms of RJ45 connectors. Please refer to the following section, PROFINET Connector
for Harsh Installation, for additional details.
Figure 2-59: Siemens Right-Angle Connector for Harsh Installation of PROFINET Option
METTLER TOLEDO IND570 Weighing Terminal Installation Manual
[Not used]
Communication Status
Module Status
2-39