Mettler Toledo IND570 Manual Del Usuario página 64

ControlNet network connections are made by using taps and drop cables from the main trunk line.
Figure 2-49 shows examples of two different ControlNet tap and drop cables. Note that the
connector may be straight or right-angled, as seen here. Either can be used with the ControlNet
interface installed in a panel mount IND570. This drop cable is not supplied by METTLER TOLEDO.
2-34 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
RJ-45 for
diagnostics
and
configuration
Channel B
Figure 2-48: ControlNet PLC Module Connections and Components
Do not plug an Ethernet cable into the RJ-45 connector shown at left in Figure 2-48. This
connection is not used.
Straight
connector
Figure 2-49: ControlNet Tap and Drop Cables
Channel A
MAC ID switches (not used)
Right angle
connector
LEDs
30205319 | 04 | 08/2016