Options - Mettler Toledo IND570 Manual Del Usuario

1.8.1.2. IDNet
The IND570 supports an IDNet scale through a PCB interface that connects to a unique bus on the
main board. This interface supports the newer T-brick style of high-precision base through the IDNet
scale card. The port provides the +12 volts and communication required to operate this newer style
base. The interface also supports M-Cell and Point-ADC. The older PIK module and PIK-brick cells
require +32 volts and are not supported by the IND570. The IDNet scale interface is approved for
use in the IND570xx version with ATEX and IECEx certification.
1.8.1.3. SICSpro Scale Platform
The IND570 supports a SICSpro platform through a PCB interface that connects to a unique bus on
the main board. This interface supports the newer PBKxxx and PFKxxx type of high-precision
platform through the SICSpro scale card. The port provides the +12 volts and communication
required to operate this newer style base. The IND570 SICSpro interface supports only those
SICSpro platforms that include the Advanced Setup Mode (ASM).
AT THIS TIME, THE SICSpro SCALE INTERFACE HAS NOT BEEN CERTIFIED FOR USE WITHIN DIVISION 2 OR ZONE
2/22 HAZARDOUS AREAS.
1.9.

Options

The following hardware and software options are available for the IND570:
•
•
•
•
•
•
•
•
•
•
•
30205319 | 04 | 08/2016

Scale Platform
Discrete I/O
- Internal, high-level and low-level discrete I/O
- Remote discrete I/O via ARM100 module
COM2/COM3 Serial Ports
Ethernet TCP/IP Port
Programmable Logic Control (PLC) interfaces, including:
Analog Output ControlNet™
Modbus TCP
PROFIBUS
Fill-570 application software
Drive-570 application software
COM-570 application software
TaskExpert™ custom application development software
USB and Ethernet adapters that make these ports accessible on the exterior of the harsh
enclosure. This option is not certified for use on the IND570xx version
Positionable brackets for wall and column mounting of the harsh enclosure

InSite SL Configuration Tool (PC based software for backup and restore)
METTLER TOLEDO IND570 Weighing Terminal Installation Manual
NOTICE
DeviceNet™
 
DP PROFINET
EtherNet/IP™
1-15