Mettler Toledo IND570 Manual Del Usuario página 36

2. Remove the two clamping brackets from the housing.
3. Locate the front panel mounting gasket (Figure 2-9) included with the terminal and remove the
4. Cut an opening in the panel or industrial enclosure per the panel cutout dimensions shown in
2-6 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
protective paper to expose the adhesive. Adhere the gasket to the rear of the front panel of the
terminal, ensuring that the gasket is flat and spaced evenly on all sides.
inches and [mm] in Figure 2-10.
NOTE: The cutout dimensions of IND570 match those of IND560.
Figure 2-8: Clamping Bracket
Figure 2-9: Front Panel Gasket
Clamping
bracket
30205319 | 04 | 08/2016