Mettler Toledo IND570 Manual Del Usuario página 66

Figure 2-52 shows the array of status indicator LEDs on the EtherNet/IP card.
For convenience, an EtherNet/IP PLC label is provided in the kit. The label can be applied to an
IND570 near the EtherNet/IP connector to help differentiate the RJ45 connector of the EtherNet/IP
PLC option from the RJ45 connector of the Ethernet TCP/IP network option shown in Figure 2-35
and Figure 2-36.
2.4.6.8. PROFIBUS PLC Option (Panel-Mount Enclosure)
The PROFIBUS PLC option board (Figure 2-55) is installed in position 3 (Figure 2-34) on the main
board.
Either a straight or a right-angled nine-pin connector can be used to make the connection to the
PROFIBUS option board installed in a panel-mount version of the IND570. The right-angle nine-pin
mating connector is Siemens part # 6ES7 972-0BA41-0XA0. The straight mating connector is
METTLER TOLEDO part # 64054361. Neither of these connectors is supplied by METTLER TOLEDO
as part of the option.
Pin assignments for the PROFIBUS PLC interface for both the harsh and the panel-mount enclosure
are shown in Figure 2-54. Follow the wiring instructions included with the connector to terminate
the wires.
2-36 METTLER TOLEDO IND570 Weighing Terminal Installation Manual
Link Activity
Activity
Figure 2-52: EtherNet/IP Status Indicator LEDs
Figure 2-53: PROFIBUS Option Board, Panel Mount Enclosure
Module Status
Network Status
30205319 | 04 | 08/2016