Relative Contraindications; Safe Handling; Product Description; Scope Of Supply - Aesculap Acculan 4 GA344 Instrucciones De Manejo

en
2.5

Relative contraindications

The safe and effective use of electrically driven products greatly depends
on influences which can only be controlled by the user. Therefore the spec-
ifications provided represent framework conditions only.
Clinically successful use of the product is dependent on the knowledge and
experience of the surgeon. The surgeon must decide which structures it is
sensible to treat and take into account the safety and warning information
contained in these instructions for use.
3.

Safe handling

WARNING
Risk of injury and material damage if this product is not used as
intended!
►
Use the product only for its intended purpose.
WARNING
Risk of injury and damage to property due to improper handling of the
product!
►
Follow the instructions for use of all products used.
■
General risk factors associated with surgical procedures are not
described in this documentation.
■
It is the operating surgeon's responsibility to ensure that the surgical
procedure is performed correctly.
■
The operating surgeon must have a thorough understanding of both the
hands-on and conceptual aspects of the established operating tech-
niques.
►
Remove the transport packaging and clean the new product, either
manually or mechanically, prior to its initial sterilization.
►
Prior to use, check that the product is in good working order.
►
To prevent damage caused by improper setup or operation, and in order
not to compromise warranty and manufacturer liability:
– Use the product only according to these instructions for use.
– Follow the safety and maintenance instructions.
– Only combine Aesculap products with each other.
►
Ensure that the product and its accessories are operated and used only
by persons with the requisite training, knowledge, or experience.
►
Keep the instructions for use accessible for the user.
►
Always adhere to applicable standards.
►
Ensure that the electrical installation of the room is consistent with the
requirements of IEC/DIN EN.
►
Do not operate the product in explosion-hazard areas.
►
Sterilize product before use.
►
When using the ECCOS holder system, adhere to the appropriate
instructions for use for TA009721, see Aesculap Extranet at
https://extranet.bbraun.com
4
4.

Product description

4.1

Scope of supply

Art. no. Designation
TA014553 Instructions for use, attachments for small drill GA344
and drill GA844
Attachments
One of the following attachments (with corresponding chuck key as appli-
cable) is additionally included with the delivery:
Art. no. Designation
GB870R Medullary reaming attachment, large Jacobs chuck
– and –
GA031R Key for large Jacobs chuck
GB871R Medullary reaming attachment AO large
GB872R Medullary reaming attachment Hudson/Zimmer
GB878R Drill attachment for Synthes 511.300
GB881R Drill attachment large Jacobs chuck
– and –
GA031R Key for large three-jaw chuck
GB882R Drill attachment small Jacobs chuck
– and –
GA062R Chuck key for small Jacobs chuck
GB884R Drill attachment AO small
GB886R Drill attachment Aesculap hexagon
GB887R Drill attachment dental shaft
GB891R Sagittal saw attachment
GB892R Reciprocating Saw attachment
GB894R Kirschner wire attachment
GB896R Screw attachment AO small
GB897R Screw attachment Aesculap hex
4.2

Components required for operation

■
Small drill GA344 (ready to use) or drill GA844 (ready to use)
■
Tool (depending on indication)
4.3

Operating principle

The attachment can be attached to the drill in three different positions,
each 120° difference.
The attachment locks automatically when attached to the drill. The
attachment can be removed by operating a rotating sleeve.
A gear in the attachment changes the motor speed.
The attachments have various integrated couplings on the working end, to
enable attachment of various tools, with adapter if necessary.