Teac DR-L700 Manual Del Usuario página 118

118
Troubleshooting 2
There is no sound or only a very low-level sound is
heard.
e Check that the speakers and components are
connected securely.
e Check the operation of the connected component.
e Check the audio output setting. (see page 100)
e The sound is muted during pause, slow-motion,
fast forward/reverse, and stepping playback.
Press the PLAY button to resume normal playback.
Severe hum or noise is heard.
e Check that the speakers and components are
connected securely.
e This unit cannot play such discs as CD-ROMs. Use
a playable disc.
Remote control doesn't work.
e When the function selected by the main unit and
remote control unit differs, remote control doesn't
work. Press the FUNCTION buttons (DVD, TUNER,
MD/CD-R, TAPE, AUX) of the remote control unit to
select correct function. (Even when the FUNCTION
buttons are pressed without pointing at the main
unit, the function of the remote control unit will be
changed.)
e If the batteries are dead, change the batteries.
e Use remote control unit within the range (5m /15ft)
and point at the front panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a strong light is near the unit, turn it off.
Cannot play.
e Load a disc with the playback side facing down.
If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Check the region code of the DVD.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it in again. This
resets the internal micro-computer which can be
disturbed during electrical
interruptions, et cetera.
ENGLISH
storms, power