Tabla de contenido

Publicidad

A
COMPONENT
VIDEO IN
18
TV (MONITOR)

Connection 1

CAUTION:
< Switch off the power to all equipment before
making connections.
< Read the instructions of each component you
intend to use with this unit.
< Be sure to insert each plug securely. To prevent
hum and noise, avoid bundling the signal
interconnection cables together with the AC
power cord or speaker cables.
Connection to a TV
Connect the unit using one of the following
terminations to your TV or monitor.
If your TV or monitor is compatible with
progressive scan, connect the TV via the
COMPONENT VIDEO jack using a component
video cable, and set the progressive mode "ON".
This connection provides the best picture quality.
Connecting the RGB SCART output (AV
CONNECTOR) using an RGB-ready SCART cable,
or connecting the COMPONENT VIDEO using a
component video cable is next to it.
S-VIDEO is your third choice. Composite video
output(SCART-COMPOSITE or VIDEO OUT) would
be your last choice.
< For better picture quality, do not connect more
than one video cable.
< Please connect this unit to a TV directly. If the TV
is connected through a video cassette recorder,
playback of a copy protected DVD disc could
result in a distorted picture quality.
A
COMPONENT VIDEO jack
If your TV or monitor has COMPONENT VIDEO IN
jack, connect them with a component video cable,
and select "COMPONENT" in the DVD SETUP
menu. (see page 102)
< If your TV or monitor is compatible with
progressive scan, connect the TV via the
COMPONENT VIDEO jack and set the progressive
mode "ON".
1. Press the POWER switch to turn the unit on.
2. Press the DVD button.
3. Press the DVD SETUP button.
"PROG OFF" appears on the front panel display.
4. Press the GUI button.
"PROG ON" appears on the front panel display.
ENGLISH

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido