Teac DR-L700 Manual Del Usuario página 20

B
C
S-VIDEO IN VIDEO IN
20
AV CONNECTOR
TV (MONITOR)
Connection 2
< When your TV or monitor isn't compatible with
progressive scan, never select "PROG ON". No
picture will be shown on the monitor.
In case you select "PROG ON" by mistake, press
the GUI button to turn off the progressive scan
mode.
B
AV Connector (SCART)
If your TV or monitor is compatible with RGB
SCART, connect the component with a 21-pin
RGB-ready SCART cable, and select "RGB" in the
DVD SETUP menu. (see page 102)
< Both audio and video signals are output from this
socket.
< The audio signal output from this socket is stereo.
C
S-VIDEO or VIDEO jacks
S-VIDEO connection is better than composite
connection.
If the component has a S-VIDEO jack, connect
them with a S-VIDEO cable.
S-VIDEO OUT (DR-L700) q S-VIDEO IN (TV)
If neither SCART nor S-VIDEO is available, connect
the component with a high quality RCA cable
designed for video applications.
VIDEO OUT (DR-L700) q VIDEO IN (TV)
CAUTION:
In the default setting, COMPONENT VIDEO OUT
jack is not active. If you want to use COMPONENT
VIDEO OUT, follow the following steps.
1. Connect the VIDEO jacks with a RCA video cable.
You can use the provided yellow cable.
2. Connect the COMPONENT VIDEO jacks with a
component video cable.
3. Turn the unit and TV on, and select "COMPONENT"
in the DVD SETUP menu. (See page 102)
4. Turn the unit off and disconnect the RCA video
cable from the VIDEO jacks.
ENGLISH