Installation Protocol - Nederman FlexFilter EX Manual De Instrucciones

EN

21 Installation protocol

The results for the following control points. For values note the value in the result column, else a tick will
suffice if the point has been performed or considered. If a value is outside the limit or a result is wrong/
missing this must be rectified before initial start-up and normal operation. Correct limits or results can be
seen within the parenthesis.
Unit number:
Control points
Application requirements limits?
Installation Area classification (22 or none)
Material MIE (>1 mJ)
Material MIT (>205 C)
Material Kst: See the product identification plate.
Material Pmax: See the product identification plate.
Material chemical / thermal reaction risk ( No)
Delivery control
Missing components
Transport damage
Pre-installation
Foundation - Traction forces
Foundation - Wind load
Foundation - Total weight
Foundation - Anchor bolts
Flame and pressure risk area
Maintenance access /filter change
Mounting
Legs
Crossbeams
TVFD
Cleaning valve
Relief Panel Sensor
48
FlexFilter EX
Date:
Performed by:
Result