Publicidad
Idiomas disponibles
Idiomas disponibles
Controls and display elements
Ignition lock with OCR function (depending
on model)
Fig. 6b
This is an ignition lock with OCR function
(= user-controlled mowing in reverse).
Starting: Turn key to the right
running, then release. The key turned to
(normal) allows mowing in the forwards direction.
OCR position: Turn key to left of normal position
to reverse mowing position
the switch (1). The indicator light (2) comes on and
indicates to the user that the device can now mow in
reverse and forwards gear.
Stopping: Turn the key to the left, to
Note
Only use the OCR function if absolutely nec-
essary, otherwise use the normal position.
The OCR function is switched off automat-
ically once the key is turned to the normal
position or the motor is shut down (stop
position or shutdown of the motor through
the safety lock system).
Choke (depending on design)
Fig. 7
To start a cold engine, pull the choke (Fig. 7a) or
move the throttle to
Throttle
Fig. 8
Set engine speed continuously.
Fast engine speed =
Slow engine speed =
Clutch pedal/brake pedal (only for
models with Transmatic and Autodrive
drive)
Fig. 9
Clutching= depress pedal half way
Braking= depress pedal all the way
Note
Also for activating/deactivating the parking
brake.
Brake pedal
Fig. 9
Braking= depress pedal all the way
Note
Also for activating/deactivating the parking
brake.
until the engine is
and press
.
(Fig. 7b).
Direction-of-travel lever (only for models
with Transmatic and Autodrive drive)
Fig. 10
Do not make any adjustments until the tractor is at a
standstill.
To do this, depress the clutch/brake pedal all the
way and keep depressed
Forwards = lever to 'F /
Idle = lever to "N"
Reverse = lever to 'R/
The device must first be stopped prior to each
change of direction.
Cutting height adjustment lever
Fig. 11
Largest cutting height - cutters top = lever to "5 (H)".
Smallest cutting height - cutters bottom = lever to "1 (L)".
PTO lever
Fig. 12
The PTO lever mechanically switches the cutter
deck on and off.
Switch off the cutter deck 0 /
= pull the lever all the way back
Switch on the cutter deck I /
= slowly push the lever forwards to the stop.
Parking brake for devices with hydrostat-
ic drive/automatic and Autodrive drive
Fig. 13
Engage the parking brake: Fully depress the brake
pedal/clutch brake pedal and move lever to position '
Release the parking brake: Fully depress the
brake pedal/clutch brake pedal and move lever to
position '
'.
Lever for speed levels/parking brake for
devices with Transmatic drive
Fig. 14
Low speed = lever to "1".
High speed = lever to "6" or "7" (optional).
Increase speed = adjust drive positions without
depressing the clutch/brake pedal.
Reduce speed = adjust drive positions by depress-
ing the clutch/brake pedal (depress halfway).
Engage the parking brake: Depress clutch/brake
pedal all the way; push lever for speed setting to
.
Release the parking brake: Depress clutch/brake
pedal all the way; push lever to speed setting.
'
'
EN
'.
13
Publicidad
