9681 Battery Pack Removal
The clipper body contains recyclable Lithium‑Ion (Li‑Ion) batteries, which are not intended to be
replaced. When your rechargeable clipper reaches the end of its useful life, the battery pack must
be removed from the clipper and be recycled or disposed of properly in accordance with your local,
state, and/or government requirements. The disposal of Li‑ion batteries as municipal solid waste
is prohibited.
The procedure below describes the removal of the battery pack for the purpose of proper disposal.
Discard the clipper after the battery pack has been removed.
1. Make sure that the ON/OFF button is in the OFF position.
2. Remove disposable clipper blade assembly.
3. Dry clipper and hands completely.
4. Remove the three housing screws.
5. Pull or pry the top and bottom housing apart from the top.
6. Pull motor and battery pack out.
7. Pull Li‑ion battery out of the assembly.
8. Recycle battery pack or dispose of appropriately.
How supplied
Components/Accessories
1. 9681 3M™ Surgical Clipper Professional
2. 9680 3M™ Clipper Blade Assembly
3. 9682 3M™ Drop‑in Charger Stand with cord (Plug Type A)*
9683 3M™ Drop‑in Charger Stand with cord (Plug Type C)
9683B 3M™ Drop‑in Charger Stand with cord (Plug Type C, Brazil only)
9684 3M™ Drop‑in Charger Stand with cord (Plug Type G)
9685 3M™ Drop‑in‑Charger Stand with cord (Plug Type I)
9686 3M™ Drop‑in‑Charger Stand with cord (Plug Type I, Argentina only)
*Not CE Marked
NOTE: The 9680 3M™ Clipper Blade Assembly is the only acceptable blade to be used on the
9681 3M™ Surgical Clipper Professional.
5