Warranties/3M Liability
Limited Warranty
This warranty is in lieu of any other warranty express or implied except as indicated below: This
3M™ Surgical Clipper Professional is warranted against any defects in material or workmanship for
a period of 2 years from the date of purchase*. If this surgical clipper is determined to be defective
within the warranty period, it will be replaced without charge by 3M. In the U.S., contact your local
3M Sales Representative or the 3M Health Care Helpline – 1 800 228.3957. Helpline personnel are
available Monday through Friday, from 7:00 AM to 6:00 PM Central Time. After business hours, a
voice prompt system will take your product complaint information. International customers, please
contact your local 3M Subsidiary for necessary shipping labels and packing list. Please include a
description of the defect with the returned unit.
This warranty does not cover damage caused by misuse, negligence, accident, abuse or alteration,
modification of the units by anyone other than 3M or affixation of any accessory not manufactured
by 3M or use of the surgical clipper with current or voltage other than that specified in this
instruction insert. Replacements after the warranty period will be made and charged to the customer
on the basis of rates which are available upon request.
EXCEPT FOR PERSONAL INJURY, 3M IS NOT LIABLE IN EITHER TORT OR CONTRACT FOR ANY
LOSS OR DAMAGE, DIRECT, CONSEQUENTIAL, OR INCIDENTAL ARISING OUT OF THE USE,
MISUSE, OR INABILITY TO USE THIS PRODUCT. All implied warranties are limited in duration to
2 years from date of original purchase.
This warranty does not apply to Australia and New Zealand. Customers should rely on their
statutory rights.
Directions for Use
To Attach a Disposable Blade to the Clipper Body:
Make sure that the ON/OFF button is in the OFF position. After removing the lid of the clipper blade
assembly blister pack and without touching the blade assembly, hold the clipper body over the
clipper blade assembly (a). Slide the new clipper blade assembly into position until it clicks (b).
To Use the Clipper:
The patient's skin should be clean. To turn the clipper on, simply push the ON/OFF button above
the LED battery gauge on the clipper to the ON position. The power indicator will light up to the
corresponding battery capacity (c).
LED Battery Gauge Operation
The top three LED light gauges will be green and the bottom two will be yellow. These gauges
indicate battery capacity. See (d) below. NOTE: When battery level is low, the lowest LED will blink
indicating re‑charge is needed. The LEDs will also blink when in the charge stand indicating that the
clipper is charging. The level of charge can be determined by the light that is blinking at that time.
a.
b.
c.
3
Percent of Charge
80-100%
GREEN
60-80%
GREEN
40-60%
GREEN
20-40%
YELLOW
0-20%
YELLOW
d.