Publicidad
Idiomas disponibles
Idiomas disponibles
xFUME POWER 350
1.4 Signs and symbols used
The following signs and symbols are used in the operating instructions:
1
A
1.5 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and shown prior to
potentially dangerous work steps. Depending on the type of danger, the following signal words will be used:
Describes an imminent threatening danger. If not avoided, it may cause severe injuries or death.
Describes a potentially dangerous situation. If not avoided, this may result in death or serious injuries.
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results, material damage, or irreparable damage to the device or
equipment.
2 Safety
This chapter warns of residual hazards that should be kept in mind to operate the product safely. Non-
observance of the safety instructions may result in risks to the life and health of personnel as well as cause
environmental or material damage.
► Observe the document entitled "Safety Instructions".
2.1 Designated use
The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. The device is used for welding and to extract welding fumes and
dust that is generated while welding. The device can be used for extraction when welding steel with a nickel-
chromium alloy content of less than 30% and for the extraction of class H12 dust. Any other use is considered
improper. Unauthorized modifications or changes to enhance the performance are not permitted.
► Do not exceed the maximum load data specified in the documentation. Overloads lead to destruction.
► Do not make any structural modifications to the product.
► Do not use the device to thaw pipes.
► Do not use or store the device outdoors where it is wet.
► Ensure that the volume flow that is led back to the work area during operation does not exceed 50% of
the supply air of the installation area. In the event of free room ventilation, the supply air flow
corresponds to one room volume per hour. This equals a ventilation rate of 1/h (supply air flow
[m³/h] = room volume [m³] × ventilation rate [1/h]).
General instructions.
Steps to be carried out in succession.
Lists.
Cross-reference symbol indicating detailed, supplementary, or further information.
Caption, item description.
DANGER
WARNING
CAUTION
2 Safety
EN - 7
Publicidad
