Publicidad
Idiomas disponibles
Idiomas disponibles
xFUME POWER 350
4.2 Control elements
The control elements are located on the control box and at the bottom of the front of the device.
4.3 Control functions
The following control functions are available:
— Inverter unit
— Manual operation
— Automatic mode
— Arc length correction
— Material selection
— Welding power adjustment
— MIG mode
— TIG mode with adjustable gas pre-flow time and slope-down time
— 2-step, 4-step, spot welding
— Crater filling – hot start – slope-down
— Save/delete individual jobs (max. 100)
— Fast arc
— Gas test
— Feed in wire
— Power selection directly via the material thickness
— Wire creep (Sts) adjustment
— Wire burn-back (bUb) adjustment
— Gas pre-flow time (PrG) adjustment
— Gas post-flow time (PoG) adjustment
— Spot time (SPt) adjustment
— Throttle strength adjustment
— Welding cable length adjustment
— Device type adjustment
— Software update for curves
— Lock/unlock control system (CODE)
— Fans/coolant pump (if available) control
— Display HOLD time adjustment
— Reset control system to factory settings (Reset)
— Special arcs (e.g. fast arc)
4 Product description
EN - 13
Publicidad
