Abicor Binzel xFUME POWER 350 Manual De Instrucciones Original página 73

xFUME POWER 350
Welding functions in standby mode
If no welding process is active (standby mode), the welding functions for each welding curve can be
individually set. If the button is pressed for longer than 1 s, the options can be set.
Briefly press the
1
Turn the right-hand knob to set the required values.
2
Tab. 9
Operating
mode
MIG
Electrode
7.10 Setting options
The following options can be set:
EC1/2
Hold
Reset
Setting the welding
torch type and earth
cable
To access the option menu, press and hold the <Fx> button for more than 8 s, then release it.
1
To switch between the option parameters, repeatedly tap the <Fx> button.
2
Turn the right-hand knob to set the value.
3
To save the settings, press the <Wire feed> button.
4
►
button to set the welding functions.
Welding function control box
Welding function Screenshot
Throttle
Start speed
Wire burn-back
Gas pre-flow time
Gas post-flow time
Crater hot start current
Crater hot start time
End crater filling current
End crater time
Slope-down speed
Spot time
Code <CODE>
Hot start
Arc force
Selection of the functions for the potentiometer
 7.12 Managing jobs on page EN-28
Sets how long the last value remains on the display after the welding
process ends.
Range: 0 s to 30 s.
Reset the control system and the memory locations
 7.12.1 Accessing and saving jobs on page EN-28
Sets the welding torch type and earth cable
 7.11 Setting the welding torch type and earth cable on page EN-28
Adjustable range
<Choc> Continuous correction of the welding
throttle from +15 (softer) to –15 (harder)
than standard (0)
<StS> 10% to 100% of the welding speed
<bUb> −60 ms (long, sharp) to +90 ms (short, ball
wire end)
<PrG> 0.0 s to 1.0 s
<PoG> 0.5 s to 10 s
<CSC> −50% to +80 % of the present welding
<tCSC> 0.1 s to 5.0 s
<CEC> −80% to +50 % of the present welding
<tCEC> 0 s to 5.0 s
<SLO> 1 V/s (slow) to 20 V/s (fast)
<SPt> 0.5 s to 10 s
For locking the control system
 7.13 Locking the control system on
page EN-28
<HSt> 0% to 150% of the welding current
<ArcF> 100% to 250% of the welding current
7 Operation
current
current
EN - 27