Abicor Binzel xFUME POWER 350 Manual De Instrucciones Original página 60

4 Product description
4.3.1 Control box
Fig. 4
A Left-hand display
B Central display
C Right-hand display
D <Welding parameters> button
E <Gas test/load> button
F <Wire infeed/store> button
L
K
J
I
H
Tab. 1
Pos. Name
A
B
C
D
EN - 14
Control box
A
Control box control elements
Left-hand display
Central display
Right-hand display
<Welding parameters> button
G <MIG/electrode/WIG> button
H <Material/auto/manual> button
I Right-hand knob
J Left-hand knob
K <Fx> button
L <Operating mode> button
C
B
G
Function
The wire feed speed in m/min (manual mode) or the arc
length correction value in V (automatic mode) is displayed.
At the end of the welding process, the final value is displayed
for a further 20 s.
Illuminated dot on the display = hold function active.
The welding voltage in V is displayed. At the end of
the welding process, the final value is displayed for
a further 20 s.
Illuminated dot on the display = hold function active.
The welding current in A is displayed during the welding
process.
If no welding process is active, the material thickness or other
parameters are displayed.
Pressing the button repeatedly switches between the welding
current and the material thickness. The appropriate LED
lights up.
If the button is pressed for less than 0.5 s, the knob can be
used to select the material thickness.
The current selection on the display is adopted.
xFUME POWER 350
D
E
F