6 Maintenance
The device is maintenance-free. In harsh environments, we
recommend regular inspections for firm seating and possible
damages at the device. Repair work may only be carried out
by the manufacturer, see Contact [} 60].
Prior to the work
1. Switch off the power supply and secure it against switching
on again.
2. Then disconnect the power supply lines physically.
3. Remove operating and auxiliary materials and remaining
processing materials from the encoder.
6.1 Disassembly
To disassemble the device, proceed in the reverse order of
the assembly, see Electrical Installation [} 51] and Mechanical
Installation [} 44].
6.1.1 Disassembling the Tapered Shaft
Unintentional seizing of the tapered shaft on the drive shaft
may require a tool to remove it.
6.2 Reassembly
Reassembling the device is only permitted under the follow-
ing conditions:
• The device is not damaged.
• The screws can be secured newly against loosening.
• All safety instructions can be complied with.
56 - EN
• All the steps described in chapter Installation [} 44] are im-
plemented.
6.3 Traceability
Identification of errors in the field
A traceability of these products is recommended. This can be
achieved for example by means of the serial number on the
type plate. Complete traceability is decisive for fast and tar-
geted reaction in the market
7 Disposal
Always dispose of unusable or irreparable devices in an en-
vironmentally sound manner, according to the country-spe-
cific provisions and in compliance with the waste disposal
regulations in force. We will be glad to help you dispose of
the devices, see Contacts [} 60].
Environmental damage in case of incorrect disposal
Electrical waste, electronic components, lubricants and other
auxiliary materials are subject to hazardous waste treatment.
Problem substances and may only be disposed of by
licensed specialist companies.
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 03
NOTICE
NOTICE