cecotec DRUMFIT WAYHOME 1800 RUNNER SPRINT Manual De Instrucciones página 63

provided, turn the left and right adjustment bolts of the rear rollers 90° clockwise. Then
switch the treadmill back on and let it run at a speed of 6 km/h. Run over the walking belt
to determine if the walking belt is still slipping. Repeat this process until the walking belt
stops slipping. Fig. 9
Storage
Store the treadmill in a closed, clean and dry place. Never leave or use it outdoors. Make sure
that the machine is switched off and the power cord is unplugged from the mains socket.
Note
Before moving the treadmill, make sure that the power switch is in the OFF position and the
power cord is unplugged from the power outlet.
Unfolding the treadmill
Hold the main frame and then gently press the piston lock with your foot. Hold the main frame
while slowly lowering it to the ground. Turn on the main switch located on the front of the
machine, near the power cable. Fig. 10
Warning
The air piston must slow down the main frame as it descends. If the frame does not slow down
as it descends, the piston may be broken.
Folding the treadmill
After using the treadmill, turn off the main switch located on the front of the machine, near the
power cable. Lift the main frame until the air piston lock holds the frame upright. You should
hear a click when the main frame has locked into position. Fig. 11
Warning
DO NOT turn on or operate the treadmill when it is folded.
Lubricating the walking belt
Correctly greasing the treadmill will prolong its life. For that reason, after the first 25 hours of
use (or 2-3 months) apply a little lubricant and then repeat the operation every 50 hours of use
(or 5-8 months).
- Checking the lubrication status of the treadmill
Lift one side of the walking belt and touch the surface of the board. If the surface is slightly
oily, no further lubrication is required. However, if the surface feels dry to the touch, apply a
little lubricant.
- How to apply the lubricant
DRUMFIT WAYHOME 1800 RUNNER SPRINT
ENGLISH
63