cecotec DRUMFIT WAYHOME 1800 RUNNER SPRINT Manual De Instrucciones página 64

ENGLISH
To lubricate the treadmill, first fold it up. There are two red openings at the bottom of the
walking belt. Put a few drops of silicone oil in each of the openings, wait a few seconds and
reopen the treadmill. The lubricant cannot leak out, so you can use the treadmill without any
problems. Fig. 12
Emergency brake
- Before starting a training session, make sure that the safety key is correctly placed in the
console and that the safety clip is securely attached to a piece of clothing. If dropped, the
clip will pull the EMERGENCY BRAKE KEY on the control panel and the treadmill will stop
immediately to help prevent injury.
- Put the safety key back on the console. Press the START button on to restart the training
session.
7. TROUBLESHOOTING
Problem
The treadmill does
not switch on
The walking belt is
slippery
The band brakes
when stepped on
The walking belt is
not centred
64 DRUMFIT WAYHOME 1800 RUNNER SPRINT
Possible causes
The machine is not plugged in.
The safety key is not properly
fitted.
The circuit breakers in the house's
electrical panel have tripped.
The main switch of the treadmill
has tripped.
The walking belt is not sufficiently
tensioned.
The walking belt is not sufficiently
lubricated.
The walking belt is too tight.
Walking belt tension is not
uniform with respect to the rear
roller.
Solution
Plug the power cord correctly into
a power outlet.
Put the safety key back on.
Turn the circuit breakers back up
or call an electrician to replace the
electrical panel.
Wait 5 minutes and try to start the
treadmill again.
Adjust the walking belt tension.
Lubricate the walking belt.
Adjust the walking belt tension.
Centre the walking belt.