Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SGP 62 M _/F / SM 62 M _/F / SM 66 M _/F / SMP 62 M _/F / SMP 66 M _/F
X
Z
Then press the Mode or Set button again
to set the end of cooking time
(pressing + or - buttons).
Cooking Time Setting
X
Z
To select the programme duration and/
or end time press the Mode or Set button
twice/three times and set the required
time with the + and – buttons.
„
„
During duration or end time
adjustment mode selection,
the Auto symbol remains lit.
„
„
The duration of a programme cannot
be prolonged once the end time is set.
„
„
The end time and duration settings
define programme start time as follows:
start time = end time - duration.
„
„
After setting the duration and end time,
the display still shows the end time.
Programme run
„
„
When the automatic programme is in
progress (and therefore the cooking
function is active), the Auto symbol
remains lit and the remaining cooking
time appears on the display in
countdown form. The symbol
remains lit.
Automatic programme end
„
„
At the end of the programme duration
or when the end time is reached, the
corresponding symbol
„
„
At the end of the automatic programme,
the Auto symbol flashes, the display
shows "End" and an intermittent
acoustic signal (which can be stopped
by pressing any button) sounds.
Timer function
The timer allows the setting of a time from
which a countdown begins. This function does
not turn the oven on or off, but only sounds an
audible alarm when the time has elapsed.
X
Z
Press the Mode or Set button once;
the display shows:
„
„
The bell symbol flashes, then the alarm
duration can be set with the + and –
buttons.
CF 65 M _/F / CM 65 M / CR 66 M _/F / CS 66 M _/F / SG 62 M _/F /
goes off.
When this function is active,
the bell symbol remains lit and
the display shows the remaining time
(countdown).
„
„
At the end of the time an acoustic
signal (which can be stopped by
pressing any button) sounds.
Modifying/deleting data
X
Z
The set data can be changed at any time
by pressing the + and - buttons together.
„
„
Cancelling the cooking duration
automatically ends the function,
and vice versa.
„
„
In case of programmed operation,
the appliance will not accept end of
cooking times prior to those of start of
cooking proposed by the appliance itself.
Switching on the first time
X
Z
When using the oven for the first time,
operate it empty with the temperature knob
set to maximum for at least 40 minutes and
airing the room.
„
„
The odour noticed during this
operation is due to the evaporation
also
of substances used to protect the
oven during the period between
manufacture and installation.
„
„
After the 40 minutes, switch off the
oven and will be ready for use after
cooling down the oven.
Suggestions
Z
Z
For successful cooking, never place your
dishes in the oven when it is cold; wait until
it has reached the set temperature.
Z
Z
During cooking, never place pots or
containers directly on the oven floor;
9 place them above the grills or drip-trays
provided, on one of the 5 shelves available;
„
„
failure to do so could damage the
oven enamel.
Z
Z
Your Franke oven uses a special enamel
which is easy to keep clean, however it is
advisable to clean it frequently to avoid
baking on grime and previous cooking
residues.
Z
Z
Any self-cleaning panels (if provided) can be
cleaned with soap and water
(see cleaning instructions).
– 12 –
Publicidad
