Publicidad
Idiomas disponibles
Idiomas disponibles
CF 65 M _/F / CM 65 M / CR 66 M _/F / CS 66 M _/F / SG 62 M _/F /
SGP 62 M _/F / SM 62 M _/F / SM 66 M _/F / SMP 62 M _/F / SMP 66 M _/F
Removing the oven door internal glass
(models CM only) (Fig. 3)
The glass of the oven door can be removed to
enable thorough cleaning of the internal glass,
by proceeding as follows:
X
Z
With the door completely open, turn the
two black blocks at the bottom of the door
180° (Fig. 3a and 3b).
Note: Make sure you turn them fully (the
blocks will click into this position).
X
Z
Carefully lift the internal glass (Fig. 3c):
the two blocks will prevent the door from
closing (if the blocks are not turned fully,
removing the glass will cause immediate
closing of the door).
X
Z
To remove the glass in between, slide out
the two side gaskets (Fig. 3d) and then lift
out the glass (Fig. 3e).
X
Z
After carrying out the cleaning operations,
refit the intermediate glass (Fig. 3f)
(the correct position is indicated by the
wording „TEMPERED GLASS" which must
be perfectly legible) by inserting it carefully
into the relevant grooves located at the top
of the door and pushing it all the way to
the end of the groove.
X
Z
Then replace both gaskets (Fig. 3g), taking
extra care to ensure they are inserted
as far as possible, until they come into
contact with the upper edge of the door.
X
Z
Finally, refit the internal glass (Fig. 3h) and
turn the two glass retaining blocks back to
their original locking position.
Never try closing the door when only
one or both blocks have partially or completely
freed the internal glass panels. After cleaning,
always remember to turn both blocks before
closing the door.
Removing the oven door (Fig. 4)
To facilitate oven cleaning, the oven door can
be removed by operating on the hinges
as follows:
X
Z
The hinges are equipped with two moveable
locks (A). Lift the lock (A) to release
the hinge.
X
Z
Then lift the door up and pull it outwards;
to do this, hold the door at the sides near
the hinges.
X
Z
To refit the door, first slide the hinges into
their grooves.
X
Z
Before closing the door, remember to
turn the two locks (A) used as hinge
attachments.
Refer to the pictures at the end of this manual.
Removing the side frames
X
Z
Bend the crosspiece engaged in the fixing
bush downwards and remove it from
the groove.
X
Z
Tilt the frame upwards by approx. 60°
and push it slightly in the direction of
inclination.
X
Z
Keeping the frame tilted, remove the two
top hooks from the respective holes.
1
Fitting the side frames
X
Z
Keeping the frame tilted, insert the top
hooks in the respective holes, pushing
lightly in the direction of inclination.
X
Z
With the frame tilted, pull in the direction of
inclination until the top hooks stop against
the outside of the compartment wall.
X
Z
Turn the frame towards the compartment
wall. Bend the crosspiece engaged in the
fixing bush downwards and remove it from
the groove.
Replacing the oven lamp
A
– 15 –
3
2
Franke ovens are
equipped with a
circular lamp
positioned in the top
left area at the back
of the compartment.
To replace the oven
lamp, proceed as
follows:
EN
Publicidad
