Publicidad
Idiomas disponibles
Idiomas disponibles
CF 65 M _/F / CM 65 M / CR 66 M _/F / CS 66 M _/F / SG 62 M _/F /
SGP 62 M _/F / SM 62 M _/F / SM 66 M _/F / SMP 62 M _/F / SMP 66 M _/F
Setting the time of day
X
Z
To set the correct time, just press the knob
three times (the LED for the clock symbol
starts blinking), then turn the left knob
(right knob for CF).
X
Z
After setting the right time, press the right
knob to confirm.
Mechanical cooking programmer
(Fig. 1d, 1e)
B
End of cooking timer knob (B)
The end of cooking timer is a practical device
that turns the oven off automatically at a set
time in an interval of 1 to 120 minutes.
9 To use the end of cooking timer, the ringer
must be wound up by turning the knob
(B) almost one full turn clockwise; then,
turning back, set the required time by
aligning the number corresponding to the
minutes with the fixed reference on the
front panel.
„
„
At the end of the set time, the ringer
sounds and the oven is automatically
switched off.
Note: The oven stays hot at around the set
cooking temperature for a long time after
it has been switched off; therefore to avoid
overcooking or burning the food, it is advisable
to remove it from the oven.
Note: To use the oven in manual mode, i.e.
without using the end of cooking timer, align
the knob (B) pointer with the fixed symbol
on the front panel. When the oven is turned off,
the end of cooking programmer can be used as
a normal timer.
Digital cooking programmer
(Fig. 1c, 1f, 1g)
It enables oven programming in the following
modes:
–
delayed start of cooking with set duration,
–
immediate start of cooking with set
duration;
–
timer.
Setting the digital clock
When the appliance has been connected to the
mains or after a power failure the display will
flash on: „0.00".
X
Z
Press the + and - buttons together for a few
seconds. The time of day can be adjusted
with the + and - buttons, while the dot
between the hours and minutes flashes.
„
„
If the time setting mode is selected
when an automatic programme is
active, the automatic programme is
cancelled.
Possible time adjustments can be made by
repeating the steps described above.
Acoustic signal frequency modification
X
Z
Press the + and - buttons (from the time
modification menu) together.
X
Z
Press Mode or Set.
X
Z
The acoustic signal frequency can be
modified by repeatedly pressing the Mode
or Set button; „ton1", „ton2", „ton3" will
appear on the display.
Manual oven operation
Once the time has been set, the programmer
automatically switches to manual mode.
Semiautomatic programme with
duration or/and end time
Starting delayed cooking with set duration
X
Z
When the time of the day is displayed, press
the Mode or Set button twice to set
a duration (pressing + or - buttons).
– 11 –
D
C
EN
Publicidad
