Publicidad
Figure 105. Leader pin reattachment kit
This procedure describes how to reattach a leader pin.
To reattach a leader pin with the IBM leader pin reattachment kit:
1. Attach the leader pin attach tool
hook
3
latches into the cartridge's door 4 . Pull the tool back to hold the door open, then slide the
tool onto the cartridge. Open the tool's pivot arm 5 .
Figure 106. Attaching the leader pin attach tool to the cartridge
2. To find the end of the tape inside the cartridge, attach the cartridge manual rewind tool
107 on page 233) to the cartridge's hub
Turn the tool clockwise until you see the end of the tape inside the cartridge. Then, slowly turn the
rewind tool counterclockwise to bring the tape edge toward the cartridge door 3 .
3. Continue to turn the rewind tool counterclockwise until approximately 13 cm (5 in.) of tape hangs
from the cartridge door. If necessary, grasp the tape and pull gently to unwind it from the cartridge.
4. Remove the rewind tool by pulling it away from the cartridge. Set the tool and the cartridge aside.
232 IBM TS4300 Tape Library Tipo de máquina 3555: Guía del usuario
( 1
in Figure 106 on page 232) to the cartridge
2
by fitting the tool 's teeth between the teeth of the hub.
IBM Confidential
2
so that the tool's
( 1
in Figure
Publicidad
