Fronius RI IO PRO/i Manual De Instrucciones página 34

Note down the IP address of the power source used:
1
Access website of the power source in the internet browser:
6
7
Note down the IDs of the desired characteristics:
8
9
10
11
12
34
Connect the power source to the computer (for example using a LAN cable)
3
1
1.9.0-16501.9508
xx.x.xxx.x
Enter the IP address of the power source in the search bar of the Internet browser
and confirm
- The website of the power source is displayed
Enter username and password
Factory setting:
Username = admin
Password = admin
- The website of the power source is displayed
On the power source website, select the "Synergic lines overview" tab
Note down the IDs of the characteristics that it should be possible to select using the
interface
On the power source website, select the tab for the interface used
For example: RI IO PRO/i
Under "Synergic line assignment", assign the program numbers (= bit numbers) the
desired characteristic IDs.
For example: Program number 1 = Synergic line ID 2501, Program number 2 = Syn-
ergic line ID 3246, etc.
- The assigned characteristics can then be called up using the interface and the
selected program numbers (=bit numbers)
Once all of the desired characteristic IDs have been assigned, select "Save assign-
ment"
- All of the program numbers with their assigned characteristic IDs are displayed
under "Actual assigned program numbers to synergic lines"
Select "Defaults" in the left sidebar of
2
the power source control panel
Select "System" in the right sidebar of
3
the power source control panel
Press the "Information" button on the
4
2
power source control panel
Note down the displayed IP address
5
(example: 10.5.72.13)
4