Publicidad
Idiomas disponibles
Idiomas disponibles
8. USER SECTION: OPERATION
8.1 Heat Pump ON/OFF
Recipes 10 and 13
Instructions on the Febos-Crono Master manual
Recipes 1 and 3
The input 102 (E+ / E-) of the TERMINAL BLOCK PCB is configured as
remote On/Off,so:
Contact open
OFF
(open)
The heat pump is in Off remotely, so it stays off,
and the SMART-MT displays "OFF".
Contact closed
ON
(closed)
The following is restored to the state before the contact was opened and
is operational:
All recipes
The SMART-MT displays the Clock or the water output Temp or Compres-
sor Step (scroll through the three displays with the keys
the Heat Pump can be turned on/off by pressing the key
If the icon is active
the PdC is on standby, then, by pressing
the PdC turns on and activates the operating mode icon
(heating) or
(cooling).
8.2 Operating mode (Heating / Cooling)
Recipes 10 and 13
Instructions on the Febos-Crono
Recipes 1, 2, and 3
The input 104 (G+ / G-) of the TERMINAL BLOCK PCB is configured as
Summer / Winter remotely, so:
Contact open
Summer
(open)
E+
102
The Heat Pump is in Summer remotely, so the operating mode is Cooling
E-
and the SMART-MT displays the icon
Contact closed
Winter
(closed)
The Heat Pump is in Winter remotely, so the operating mode is Heating
E+
102
and the SMART-MT displays the icon
E-
or
) and
.
8.3 Consent from Ambient Thermostat
Recipes 10 and 13
Instructions on FEBOS CRONO manual
Recipes 1, 2, 10 and 13
Input 101 (D+ / D-) of the TERMINAL BLOCK PCB is configured as Envi-
ronment Thermostat Consent, so:
Contact closed
Consenso da Termostato
The consent of the Ambient Thermostat is active and the Heat Pump oper-
ates to heat/cool the water to the target temperature.
On the SMART-MT the icon
.
.
Room
Ambiente
thermostat
or
becomes intermittent.
EN
EN
127
Publicidad
