Publicidad
Idiomas disponibles
Idiomas disponibles
1. Description DEI COMPONENTI
5. INSTALLATION
5.7 Connection Specifications Recipe 2 (C400=2)
Configuration for connection to the ECO HYDRO KIT
ELECTRICAL CONNECTIONS ON PCB-TERMINAL BLOCK
DHW Sensor
Consent from
Room Thermostat
Water flow
meter
Compressor frequency
limitation
Summer (open)
Winter (closed)
Set Point 2 consent for Fancoil
Note:
It is possible to connect the FEBOS-CRONO to the RS485- and RS485+ contacts of the TERMINAL BLOCK PCB, to use it as a display panel for the operating parameters of the
heat pump and the system, and to carry out the On/Off and Summer/Winter of the heat pump itself.
To use, it is necessary to configure the FEBOS-CRONO Window Contact as NC (Normally Closed), and make sure that contact 102 on the TERMINAL BLOCK board is jumpered.
To use the FEBOS-CRONO also as a thermostat/humidistat, set a recipe 10, also including the installation of the flow meter.
Brown
Black
Blue
Consent to DHW integration electric
heater (ECO HYDRO KIT)
R1 out
T1 out
T2 out
Additional heater
consent
L1 out
L2 out
P1
in
P0
in
M1 out
M2 out
P2 out
W1 out
U1 out
EN
EN
etiKa Evo
HP signal in alarm
Booster Pump
Consent to 3-way DHW valve
99
Publicidad
