Publicidad
Idiomas disponibles
Idiomas disponibles
1.3.
Applied Directives and Technical Standards
Every machine destined for countries within the European Union (EU), or countries for which there is an agreement
with the EU regarding product legislation, is supplied with a Declaration of Conformity in accordance with the
Machinery Directive 2006/42/EC.
As the machine is covered by Annex IV, the manufacturer applies the examination procedure for EC type-exami-
nation as set out in Annex IX, plus internal checks on the manufacture of the product as set out in Annex VIII of
Directive 2006/42/EC.
The relevant manufacturer's Declaration of conformity is attached to the Use and Maintenance Manual.
NOTE: In the case of supplies of products in non-EU areas, unless otherwise contractually agreed between the
parties, Campagnola S.r.l., for the purposes of product design and manufacture, conforms for the applicable parts,
and in accordance with the state of the art, to the ISO, IEC std applied to the product.
1.4.
Receiving the product
When receiving the product, make sure that:
•
it has not been damaged during transportation;
•
the supply matches the order (see "Product description" - chap. "Technical specifications").
If problems arise, please contact C.A.T quoting all details indicated on the rating plate (refer to "Product Identifi-
cation" - chap. "Technical specifications").
1.5.
Warranty
Refer to the dedicated area on the Campagnola website for the general warranty conditions, at the following ad-
dress:
http://www.campagnola.it; or send a written request by fax to 39 051752551 or an
star@campagnola.it
e-mail to:
CAUTION!
For warranty claims, according to the above-mentioned points, the product to be repaired must always be
accompanied by the properly filled-in warranty card and the corresponding proof of purchase with date of
purchase (invoice or any other document with legal value).
2.
WARNINGS
2.1.
Warnings
CAUTION!
Before using the machine, read the use and maintenance instructions carefully and understand them in
their entirety.
2.1.1.
Results of noise and vibration exposure tests.
The Kronos product is assembled by the user in the various permissible configurations consisting of:
Power unit
-
-
Extension pole with variable lengths as required and ordered
-
Cutting head
0310.0360 Use and Maintenance Manual - Translation
of Original Instructions - Rev: 00, Date 07/02/2024
".
Page 33
Publicidad
