CAMPAGNOLA KRONOS 58 Manual De Uso Y Mantenimiento página 50

6.2.3. Sharpening the chain
CAUTION!
Wear heavy-duty gloves.
CAUTION!
To sharpen and service the chain, follow the manufacturer's instructions. Decreasing the height of the
depth limiter could increase the kickback risk.
CAUTION!
After sharpening the chain 3 or 4 times, check and file the depth limiter if necessary using a flat file, then
round the front tip.
The chain pitch is 1/4", so use a 4 mm diameter file and a flat file.
• Always sharpen the chain from the inner part of the cutting side towards the outer part, keeping a 35° inclina-
tion.
• After sharpening, all cutting teeth must be of the same length and width.
Maintain the
angle
File as shown
Place the depth gauge firmly on the chain so that the depth limiter protrudes. File the protruding part of the depth
limiter until it reaches the same level as the depth gauge. Round the front angle of the depth limiter.
Depth gauge
Upper corner of the
plate
Page 50
Side angle of the plate
Grip 10°
File until it is flat
like the gauge
Cutting angle of the upper side
of the plate
0310.0360 Use and Maintenance Manual - Translation
of Original Instructions - Rev: 00, Date 07/02/2024
When filing, keep a space equal to
1/5 of the file diameter
Depth gauge
Round the
corner
Parallels