3M PELTOR WS LiteCom Plus MT73H7A4310WS6EU Manual Del Usuario página 13

earmuff battery is approximately 18 hours.
• This product may be adversely affected by certain chemical
substances. Further information should be sought from the
manufacturer.
• These earmuffs are of large size range. Earmuffs complying
with EN 352-1 are of "medium size range" or "small size
range" or "large size range". "Medium size range" earmuffs will
fit the majority of wearers. "Small size range" or "large size
range" earmuffs are designed to fit wearers for whom
"medium size range" earmuffs are not suitable.
• These earmuffs attached to head protection and/or face
protection devices are of large size range. Earmuffs attached
to head protection and/or face protection devices complying
with EN 352-3 are of "medium size range" or "small size
range" or "large size range". "Medium size range" earmuffs will
fit the majority of users. "Small size range" or "large size
range" earmuffs are designed to fit users for whom 'medium
size range' earmuffs are not suitable.
• The output of the audio circuit of this hearing protector may
exceed the exposure limit level.
• The entertainment audio signal does not exceed 75.4 dB(A).
The maximum SPL is 75.4 dB(A) at – 10 dBFS.
2.2. CAUTION
• Risk of explosion if battery is replaced by an incorrect type.
• Do not charge batteries in temperatures above 45°C (113°F).
• Use only 3M™ PELTOR™ Battery ACK081 charged with
cable 3M™ PELTOR™ AL2AI connected to a 3M™ PELTOR™
Power supply FR08
• With lithium-ion batteries, there is a risk of fire and burns.
Do not open, crush, heat above 55°C (131°F), or incinerate.
• Always use product-specific 3M™ PELTOR™ replacement
parts. Use of unauthorized replacement parts may reduce the
protection you receive from this product.
• Obey the instructions given in this manual. Tampering with
the product may void the IP54 approval of this product.
• Dust protected and water resistant when worn properly.
2.3. NOTE
• When worn according to these user instructions, this hearing
protector helps reduce exposure to both continuous noises, such
as industrial noises and noises from vehicles and aircraft, as well
as very loud impulse noises, such as gunfire.
It is difficult to predict the required and/or actual hearing
protection obtained during exposure to impulse noises. For
gunfire, the weapon type, number of rounds fired, proper
selection, fit and use of hearing protection, proper care of
hearing protection, and other variables will impact performance.
To learn more about hearing protection for impulse noise, visit
www.3M.com.
• This hearing protector is provided with level-dependent
attenuation. The wearer should check correct operation before
use. If distortion or failure is detected, the wearer should refer to
the manufacturer's advice for maintenance and replacement of
the battery.
• This hearing protector is provided with safety related audio
input.
The user should check correct operation before use.
If distortion or failure is detected, the user should refer to the
manufacturer's advice.
• This hearing protector limits the entertainment audio signal
to 82 dB(A) effective to the ear.
• Operating temperature range: –20°C (–4°F) to 50°C (122°F).
3. APPROVALS
EU
Hereby, 3M Svenska AB declares that the Bluetooth
radio communication is in compliance with Directive 2014/53/EU
and other appropriate directives to fulfill the requirements for
the CE marking.
3M Svenska AB also declares that the PPE type headset is in
compliance with Regulation (EU) 2016/425.
The PPE is audited annually by SGS Fimko Ltd., Takomotie 8,
FI-00380 Helsinki, Finland, Notified Body No. 0598 and type
approved by PZT GmbH, Notified Body No. 1974,
Bismarckstrasse 264 B, 26389 Wilhelmshaven, Germany.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020, EN 352-8:2020.
GB
Hereby, 3M Svenska AB declares that the Bluetooth
radio communication is in compliance with Radio Equipment
Regulations 2017 and other appropriate regulations to fulfill
the requirements for the UKCA marking.
3M Svenska AB also declares that the PPE type hearing
protector is in compliance with Personal Protective Equipment
Regulations (Regulation 2016/425 as brought into UK law
and amended).
The PPE is audited annually, and type approved by SGS
United Kingdom Limited, Rossmore Business Park, Ellesmere
Port, Cheshire CH65 3EN, UK, Approved Body No. 0120. The
product has been tested and approved in accordance with
EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020, EN 352-8:2020.
0120
EU and GB
The applicable legislation can be determined by reviewing the
Declaration of Conformity (DoC) at www.3M.com/peltor/doc.
The DoC will also show if some other type approvals are also
applicable. When retrieving your DoC, please locate your part
number. The part number of your earmuffs can be found at
the bottom of one cup. An example can be seen in the picture
below.
A copy of the DoC and additional information required in the
Directives can also be obtained by contacting 3M in the
country of purchase. For contact information, see the last
pages of this user instruction.
EN
and
®
and
®
2