Flash Opt Optimisation Programme - SICE S 63 Manual De Instrucciones

FLASH OPT
OPTIMISATION
PROGRAMME
This procedure minimises any vibration still
present on the vehicle while running even
after accurate balancing, thus minimising
the rim-tyre coupling run-out.
Based on our experiences, the programme
can be recalled every time it is convenient
to minimise the running noise produced by
the vibrations mentioned above.
The calculations performed by this pro-
gramme are based on the unbalance values
measured during the last spin performed
which must therefore refer to the wheel
being serviced.
Proceed as follows to recall this programme:
- Press the
the LED corresponding to the OPT pro-
gramme illuminates.
- Press the key
selection.
Once the selection has been made, the
machine will indicate whether it is conven-
ient to proceed with the programme. To do
this the machine will flash the following
message:
• "YES OPT" if it is worth executing the
programme;
• "NO OPT" if it is not.
Press the
gramme and return to the STD environ-
ment;
When the procedure is called up, the fol-
lowing appears on the left display: "OP.1";
OPT 1
- Move valve to 12 o'clock.
- Confirm the operation by pressing the
User manual S 63
and keys until
to confirm the
key to exit the pro-
key.
OPT 2
- Rotate the wheel until you reach the posi-
tion indicated by the illuminated central
elements of the position indicator;
- mark the 12 o'clock position on the outer
tyre side using a piece of chalk;
- Press the
- If the key is pressed now, the
system temporarily exits from the "OPT"
programme (to return, repeat the initial
"OPT" programme activation procedure).
- Disassemble the wheel from the wheel
balancer.
- Rotate the tyre on the rim until the
chalk mark is in line with the valve (180°
rotation);
- Remount the wheel on the wheel balancer.
- Turn the wheel until the valve is in the 12
o'clock position;
- Press the
- Perform a spin.
The improvement preview can be displayed
before continuing with the last phase of the
optimisation procedure. If the improvement
is considered insufficient or if no further
significant improvements can be achieved,
press the key to exit.
Proceed as follows to display the improve-
ment that can be achieved:
- press the
unbalance values of the wheel as currently
mounted on the wheel balancer are now
shown on the displays;
button.
button.
button once: the actual
67